ADC MM702G, User Manual

Page: 112 / 168

Set Up the LAN
104 MM701G and MM702G User Manual
S
ET
U
P THE
LAN
If you are operating in Router mode and in a LAN environment, then you also need to set your
LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of 10.0.0.1 for the Ethernet Port IP Address, and
255.255.255.0 for the subnet mask.
1 From the System Management main menu ( page 102 ), enter 2 to display the LAN Configuration
menu.
2 Configure the following parameters, 1 through 6, for the PPP session:
LAN Protocol
Enter
1
then select one of the following for DHCP protocol:
•
1
—
Spanning Tree
where you select
1
to
Disable
spanning tree protocol or select
2
to
Enable
spanning tree protocol for all bridging sessions.
•
2 — DHCP Client mode where you select 1 to Disable DHCP client mode or select 2
to Enable DHCP client mode for the modem.
If a DHCP server is not set up and active on your LAN, do not enable DHCP
client. DHCP Client mode is recommended for use only when bridging is used
as the LAN protocol.