ADC Digivance CXD, Operation Manual

Page: 55 / 74

ADCP-75-192 • Issue 2 • June 2007
Page 43
© 2007, ADC Telecommunications, Inc.
The RFA configuration options are pcsA, pcsB, pcsC, pcsD, pcsE, pcsF, smrA, smrB, pcsADB,
pcsEFCG, smrA, smrB, cellA, and cellB.
3.8.2.6 Multicoupler/LNA Connection
transceptRanNodeTable.transceptRanNodeRdcZMucOrLnaConnection, Z=1-5
These entries manually record the RF connection path between the RAN downConverter’s
outputs and the RFA. For example, if the RFA attached to RDC A2’s output is connected to a
PCS ADB RFA, then
transceptRanNodeTable.transceptRanNodeRdcZMuOrLnaConnection
should be set to “pcsADB”. This data is best gathered at installation time. Repeat for all RUCs
and RFAs as necessary.
The Multicoupler/LNA configuration options are pcs, cell, smrA, smrB, cellSMR
3.8.2.7 Invalid
transceptRanNodeExtTable.transceptRanNodeExtInvalid
This entry resides in the “expansion” table of the RAN Node MIB. If a node in the network that
is now found to be a Hub node resides in the RAN Node MIB (i.e. was previously resident in a
RAN), the Invalid field in the RAN Node MIB will be set to true. This will alert the NMS to
clear that node entry in the RAN Node MIB.
3.8.2.8 Clean
transceptRanNodeExtTable.transceptRanNodeExtClean
This entry resides in the expansion MIB table of the RAN Node MIB. The RAN Node MIB
keeps a history of every RAN ever seen by the Hubmaster node. At times these entries will
become invalid as CPUs are swapped out, etc. To remove old and unwanted node information
from this MIB, the operator must set the “Clean” value to 1. The old node information will be
removed. No further action is required. Note that if the node is present and valid, it will re-
appear within seconds, even if it is cleared.
3.8.2.9 RAN Disable
transceptRanNodeDisableTable.transceptRanNodeDisableRanState
This entry in the RAN Node MIB allows a given RAN to have all of its PAs disabled(*). By
setting this field to “disabled”, the Digivance CXD/NXD software will automatically push the
value down to the Network Node MIB on the selected RAN, which will cause all PAs to be
turned off. If this value is set to “enabled”, then the RAN Disable states that are maintained on a
per-tenant basis in the Tenant OAM MIB will be used instead.
Note: This overrides the tenant OAM MIB setting