ADC Campus-REX2 RS, User Manual

Page: 42 / 166

Chapter 3 - Configuring the REX2
30 Campus-REX2 RS Interface Card User Manual
A
CCESSING THE
REX2 C
ONFIGURATION AND
S
TATUS
S
CREEN
From the Main Menu ( page 1-14 ), type then press to access the
REX2 Configuration and Status screen.
C
ONFIGURING THE
C
AMPUS
-REX2
AS A
B
RIDGE
A bridge moves information across a network from a source to a destination
at the link layer (of an OSI reference model). The information is sent to a
physical address known as a Media Access Control (MAC) address. See
“MAC-Level Bridging and Spanning Tree Protocol” on page 124 for more
information about bridging.
This section describes how to configure the bridge (default setting) options
found on the screen shown above for the Campus-REX2, including:
• “Configuring Bridge Protocol, Encapsulation and Timing” on page 31
• “Configuring Bridge Features” on page 32
– “Configuring Spanning Tree Protocol” on page 33
– “Configuring the Bridge Unit IP” on page 38
• “Saving the Bridge Configuration” on page 40
• “Accessing the Bridge and ARP Tables” on page 41
2
ENTER
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Local I/F: REX2
Remote Unit ID: Remote I/F: REX2
Circuit ID:
REX2 CONFIGURATION AND STATUS
LAN STATUS: 100BaseT, Full Duplex, Up
LINE STATUS: Standard, Auto, T1, Up
MAC ADDRESS: 00:20:A7:01:02:08
1) Network Protocol: Bridge (Bridge, Router)
2) Encapsulation: cHDLC (cHDLC, PPP)
3) Timing Source: Internal (Internal, HDSL)
4) BRIDGE CONFIGURATION
5) BRIDGE STATISTICS
6) SNMP CONFIGURATION
(R)eturn
ENTER CHOICE>