ADC Campus-REX2 RS, User Manual

Page: 21 / 166

Chapter 1 - Installing and Accessing the REX2
Campus-REX2 RS Interface Card User Manual 9
Connecting to the Campus Unit Console Port
Use a terminal or a PC with terminal emulation software (both will be referred
to as PC) connected to the Console port to configure Campus system options,
manage the unit, and generate system reports. The PC connects to the Console
port on the desktop unit, the line unit (in a Campus-Star chassis), or the
CMU-810 installed in the Campus-Star chassis.
1 Connect the Console adapter into the standard 9-pin COM port on the PC
and tighten the attached screws.
2 Plug one end of the console cable into the PC’s COM port or console
adapter, then do one of the following:
•
If the Campus-REX2 is installed into a desktop unit, connect the
other end of the console cable into the desktop unit Console port.
120
VA
C@60Hz
or 220
VA
C@50Hz .2A Max
REX
2 R
outer
Lin
k/A
ctivity
MD
I-X
MD
I
PC
HU
B
10 Base-T
100 B
ase-Tx
PC or terminal
9-pin COM
port
Campus-RS Desktop Unit
Console port
Console adapter
Black cable
(Category 3)