ADC Campus-REX2 RS, User Manual

Page: 128 / 166

Chapter 7 - Using the LCD for Configuration and Management
116 Campus-REX2 RS Interface Card User Manual
Ethernet Information
You can view the following information about the Ethernet port:
•
Link Status
•
MAC address
•
current 10/100Base-T status
To view Ethernet information:
1 Press Escape until
CAMPUS RS I/F: REX2
is displayed.
2 Press Next twice.
REX2 CONFIG & STATUS
is displayed.
3 Press Enter.
CONFIGURE REX2 SETTINGS
is displayed.
4 Press Next twice to view the status of the LAN link.
5 Press Next to view the status of the LAN link.
6 Press Next to view the
MAC ADDRESS
.
HDSL Margin
You can view the current HDSL loop margin values, measured in dB, for the
local and remote HDSL loop. The listed values represent the margin relative
to a signal-to-noise ratio required for a Bit Error Rate (BER) of 10
-7
. A margin
value greater than zero indicates a performance of better than 10
-7
. The
system provides a minimum margin of 6 dB, which translates to a
performance of 10
-10
BER or better.
To view the HDSL margin:
1 Press Escape until
CAMPUS RS I/F: REX2
is displayed.
2 Press Next.
HDSL LINK CONFIG & STATUS
is displayed then
press Enter.
3 Press Next until
MARGIN
is displayed.
P
ORT
S
TATISTICS
You can view Bridge and Router Port Statistics for the LAN (Ethernet) and
Line (HDSL) ports: