ADC Campus-REX2 RS, User Manual

Page: 114 / 166

Chapter 7 - Using the LCD for Configuration and Management
102 Campus-REX2 RS Interface Card User Manual
2 To select the transceiver mode:
a Press Next until
XCVR Mode
is displayed.
b Press Enter.
c Press Next until your choice is displayed:
•
Master
initiates the HDSL link. The other Campus unit must
be set to Slave or Auto.
•
Slave
waits for the other Campus unit to initiate the HDSL
link. The other unit must be set to Master or Auto.
•
Auto
(default) automatically switches between Master and
Slave until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two
Campus units when attempting to establish an HDSL link.
d Press Enter.
3 To configure
LOOP MODE
, do the following:
a Press Next to display
LOOP MODE
.
b Press Enter.
c Press Next to change the setting from 1 Loop (default) to 2 Loop,
then press Enter. The LCD displays
LOOP MODE=2 Loops
.
4 To configure
HDSL RATE
, do the following:
a Press Next to display
HDSL RATE
.
b Press Enter.
It is recommended that you leave the Transceiver Mode
option set to Auto unless you require that a particular end of
the HDSL connection be the Master or Slave.
Also, this value cannot be changed if the HDSL link is up.