ADC AVIDIA SWD4573I1, User Manual

Page: 197 / 658

Chapter 8: Configuring ATM Virtual Circuits
Avidia System Configuration and Management User Manual 171
Configuring Cell Channel Card PVCCs
You can configure cross-connect PVCCs between cell-based channel cards and either line cards
or the management card. You configure PVCCs from the
::pvcc=>
prompt. From the
::root=>
prompt, type the following command then press to display the
::pvcc=>
prompt.
configuration atm cell pvcc
Adding Cell Channel Card PVCCs
From the
::pvcc=>
prompt, do one of the following:
• To add one PVCC, type the new command in the following format then press . The
PVCC table index number is automatically assigned.
new <src port> <vpi> <vci> <dst port> <vpi> <vci>
[-admin (up|down)][-txtraf <src index>] [-rxtraf <src index>]
[-backup [<lport> <vpi> <vci>]]
• To add multiple PVCCs with the same traffic profile, type the range command in the
following format then press
.
range <#pvcs> <src port> <vpi> <vci> <dst port> <vpi> <vci>
[-admin (up|down)][-txtraf <src index>] [-rxtraf <src index>]
[-y]
Parameters
<#pvcs>
The number of PVCCs you want to create with the same traffic profile. See the table on
page 24 to verify that the ports you plan to use for the PVCCs support the number of
PVCCs you intend to create.
<src port>
One of the PVCC ports (format slot.port). This can be either the line card or the channel
card port.
<lport>
The other PVCC port (format slot.port). This can be either the line card or the channel card
port.
<vpi>
The VPI associated with the preceding
<port>
parameter in the command line. See the
table on page 24 for a summary of the supported VPI ranges for each card.
ENTER
ENTER
ENTER