150-712-200-02
Installation
HRE-712 List 1 and List 2
July 26, 2000
9
Large Pole Mounting the HRE-712 List 1
This procedure describes how to mount the enclosure on a pole with a diameter greater than 7 inches (17.78 cm).
shows the mounting bracket.
Have the following equipment ready before you begin:
•
Four
3
/
8
-inch (0.952 cm) lag bolts, 4 inches (10.16 cm) long minimum
•
Four
3
/
8
-inch (0.952 cm) washers
•
One wrench
•
One pencil
•
One drill with a
1
/
4
-inch (0.635 cm) bit
To mount the enclosure, follow these steps:
1
Select a mounting location on the pole.
2
Remove the enclosure base mounting bracket from the mounting bracket by removing the four bolts that
connect each side plate shown in
3
Position the mounting bracket with the stub down against the pole and mark the location of the top outside
mounting holes. Use the four corner mounting holes for this application. Remove the mounting bracket.
4
Drill four
1
/
4
- inch (0.635 cm) diameter holes 3 inches (7.62 cm) deep at the locations marked in
.
5
Start an anchor bolt in each of the two top matched mounting slots by tightening the bolts into the pole
approximately
2
/
3
of an inch.
6
Insert the lag bolts into the two holes on the outside bottom of the mounting bracket. Tighten the lag bolts.
7
Secure the enclosure bracket to the pole by securely tightening all lag bolts.
8
Reattach the enclosure base mounting brackets with the four side plate bolts and torque the mounting bracket
bolts 30 to 40 inch-pounds (3.4 to 4.5 Newton-meters).
9
If the cable stub connects to an underground cable, dress the cable down the pole to the splice case. If the
cable stub connects to an aerial cable, form a drip loop in the cable and dress it up the pole to the splice case.
Flat Surface Mounting the HRE-712 List 1
This procedure describes how to mount the enclosure on a flat surface. You must allow room for enough top
clearance to remove the cover. Allow at least 5 inches (12.7 cm) of clearance above the dome, if the 31° tilt feature
is used. Allow at least 13 inches (33.1 cm) of clearance, if the tilt feature is not used.
shows
the mounting bracket.
Have the following equipment ready before you begin this procedure:
•
Four
3
/
8
-inch (0.952 cm), 16 NC anchor bolts, 2
1
/
2
inches (6.35 cm) long for wall mounting
•
Four
3
/
8
-inch (0.952 cm) washers
•
One wrench
•
One pencil
•
One drill with a
1
/
4
-inch (0.635 cm) bit
To mount the enclosure, perform these steps:
1
Select a mounting location on a wall.
2
Remove the enclosure base mounting bracket by removing the four bolts that connect each side plate, as
shown in
