800-357-104-01, Revision 01
Installing Multiplexers
HMS-357 List 4 and List 5
September 29, 2000
51
HXU
-35
9
Configuring the STS-1 Transport through the Config Menu
Figure 32.
Setting Up the STS-1 Transport Through the HXU-359
Step
Procedure
Installer Check
ü
ü
ü
ü
1
From the Config
submenu, choose Transport, and then press
.
For more information on navigating through the menu system, refer to the procedures detailed in
“Setting Up Basic System Parameters through the Config Menu” on page 45
H
2
Set Primary State to OOS-A using the
,
and then press
.
H
Do not configure the transport as OOS-M or OOS-A when it is selected as a clock
synchronization source.
3
Select the Config
menu again, choose Transport
,
and then press
.
H
4
Enter the Tx Path Trace transmit path trace string.
String can be no longer than 40 characters.
H
5
Set the Data Communications Channel (DCC) to ON.
H
6
Set Loopback to
NONE and then press
.
H
7
Set Primary State to IS and press
.
H
8
Exit the Network Status screen by pressing
and then pressing
.
H
9
If you plan to install a fan assembly, proceed to
“Installing a Fan Assembly (Optional)” on page 54
,
otherwise, proceed to
“Installing a Line Unit (HLU)” on page 56
.
H
Installer Signature
?
?
?
?
Date
Main
Monitor
History
Config
Test
Inventory
Quit
Help
+-----------------------Transport Configuration----------------------+
|
|
|
+----------------------------------------------------------+
|
|
|
|
|
|
| Primary State : IS
|
|
|
|
|
|
|
| Rx Path Trace : abcdefghijklmnopqrstuvwxyz
|
|
|
|
|
|
|
| Tx Path Trace : abcdefghijklmnopqrstuvwxyz
|
|
|
|
|
|
|
| DCC :
ON
|
|
|
|
|
|
|
| Loopback :
NONE
|
|
|
|
|
|
|
+----------------------------------------------------------+
|
|
|
| (TAB) next field (Spacebar) next value (ENTER) activate (ESC) quit |
|
|
+--------------------------------------------------------------------+
ID: ADC | Card 'B'
05/19/00 05:40:16
ALARMS: WARN
Config
ENTER
SPACEBAR
ENTER
ENTER
ENTER
ENTER
ESC
ENTER
