ADC 150-2205-04, Installation And Verification Manual

Page: 53 / 112

800-357-104-01, Revision 01 Installing Multiplexers
HMS-357 List 4 and List 5 September 29, 2000 41
HXU-3
5
8
Configuring DS1 Services through the Config Menu
Figure 25. Setting the T1/E1 Ports Through the HXU-358
Step Procedure Installer Check
ü
ü ü
ü
Use , , , to navigate through shelf options and settings.
1 From the Config menu, select E1/T1 Ports and then press .
For more information on navigating through the menu system, refer to the procedures detailed in
“Setting Up Basic System Parameters Through the Config Menu” on page 39 .
H
2 To configure any of the 28 ports, select the port and change its Srvc Mode to MEM-ADMIN by
pressing the
.
H
3 Configure the following options:
• Type of service T1 or E1 (T1 default)
• Line code for T1 (Code)
– AMI
– B8ZS (default)
• Line code for E1 (Code)
– HDB3
• Line buildout (LBO) options for the channel [133 (default), 266, 399, 533, or 655 feet].
Pertains to T1 only, not applicable for E1.
H
In the Soneplex WBS-3190 system, these settings must match the HLU settings (not the
default settings).
If an HCC-319 List 1 and List 2 Cut-through card is used, these settings should match those
of the external line connected to the port.
4 Repeat Steps 1 and 2 for each service you are configuring.
H
Main Monitor History Config Test Inventory Quit Help
+-------------------+
|
T1/E1 Ports |
+--------------------------------------------------------------------+
|Port
Srvc Mode LBO Code T1/E1 | Port Srvc Mode LBO Code T1/E1|
| 1 MEM-ADMIN n/a HDB3 E1 | 15 OUT-OF-SRVC 133 B8ZS T1 |
| 2 OUT-OF-SRVC n/a HDB3 E1 | 16 OUT-OF-SRVC 133 B8ZS T1 |
| 3 OUT-OF-SRVC n/a HDB3 E1 | 17 OUT-OF-SRVC 133 B8ZS T1 |
| 4 - - - | 18 OUT-OF-SRVC 133 B8ZS T1 |
| 5 OUT-OF-SRVC 133 B8ZS T1 | 19 OUT-OF-SRVC 133 B8ZS T1 |
| 6 OUT-OF-SRVC 133 B8ZS T1 | 20 OUT-OF-SRVC 133 B8ZS T1 |
| 7 OUT-OF-SRVC 133 B8ZS T1 | 21 MEM-ADMIN 133 B8ZS T1 |
| 8 OUT-OF-SRVC 133 B8ZS T1 | 22 OUT-OF-SRVC 133 B8ZS T1 |
| 9 OUT-OF-SRVC 133 B8ZS T1 | 23 OUT-OF-SRVC 133 B8ZS T1 |
| 10 OUT-OF-SRVC 133 B8ZS T1 | 24 OUT-OF-SRVC 133 B8ZS T1 |
| 11 OUT-OF-SRVC 133 B8ZS T1 | 25 OUT-OF-SRVC 133 B8ZS T1 |
| 12 OUT-OF-SRVC 133 B8ZS T1 | 26 OUT-OF-SRVC 133 B8ZS T1 |
| 13 OUT-OF-SRVC 133 B8ZS T1 | 27 OUT-OF-SRVC 133 B8ZS T1 |
| 14 OUT-OF-SRVC 133 B8ZS T1 | 28 OUT-OF-SRVC 133 B8ZS T1 |
+--------------------------------------------------------------------+
Use <Spacebar> to cycle through option settings and <Enter> to activate
ID: 123456 | Card 'A' 01/18/00 14:12:15 ALARMS: MAJ
← ↑ → ↓
ENTER
SPACEBAR