ADB EURODIM TWIN TECH, Installation Manual

Page: 150 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 48
Issue 1.1
Important note : The scan can only be conducted if there is no sinewave module present in the
cabinet, even if it is not selected for the scan. The sinewave modules need to be
removed from the cabinet before launching the scan
The result of the measurement appears in the "MEASUREMENT" column.
The following information can be found:

Load value,

No load,

Overload,
There is an overload if:

for a module of 3KW, a load > 4KW has been measured,

for a module of 5KW, a load > 7KW has been measured,
The circuit currently being scanned is automatically highlighted. This function vanishes as soon as
you use the dial or select another output on the touchscreen. To find this function, press the
number “6” on the numerical keyboard.
When the load scan is completed, we can verify the differences in the table between the modules
recorded (left-hand column) and the load values measured (right-hand column).
The ≠ sign
appears in the central column in the event of an inconsistency.
33. Module Measurements Menu
This function displays the values measured for the sinewave and thyristor modules with a full-
diagnostic option
Only the sinewave or thyristor/fluo modules with full-diagnostic option can give measurements or
diagnostic. The fluo and thyristor modules without this diagnosis will always give
N/A (not
available).