ADB EURODIM TWIN TECH, Installation Manual

Page: 148 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 46
Issue 1.1
32. Loads Scanning Menu - Scan
Important : this function is only accessible if the sequential diagnostic kit has been installed in the
cabinet. In effect, it is used to measure the neutral current on the module power line
(busbar).
This function is used to launch a test verify the loads present at the output of each circuit using a
current measurement in relation to the loads provided by the "Load verification
– Learn" menu.
32.1 Selecting the outputs to be scanned
There are several ways to manually select the outputs that we wish to scan:

By touching the module/dimmer number,

By selecting the row using the wheel by pressing down,

By positioning on the row using the wheel and by pressing key 1 to select (press key 0 to
deselect)
A validation symbol appears in front of the module/dimmer number.
Important note : It is not possible to select a sinewave or FLUO module circuit for the scan (see
status).
A circuit cannot be selected if the switch law is applied (see information in Status)
because in this case, this circuit‟s load is not dimmable
A circuit cannot be selected if it is defined as "Non dim" (see information in
Status) because in this case, this type of module does not enable dimming
Manual
selection =
√