ADB EURODIM TWIN TECH, Installation Manual

Page: 145 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 43
Issue 1.1
After start up the following information is available:

There is no load present in the "EDIT" column (left-hand column),

The information displayed in the "MEASUREMENT" column is "unknown".
The "DIFF." column is used to check whether the information in the left-hand and right-hand
columns is the same or different (= or ≠).
The load connected at the output of each circuit can be defined manually or automatically.
31.1 Manually selecting the loads
To select a circuit, position on the row (highlighted), either by touching the screen or using the
wheel.
To edit and select a load:

Touch the screen to select the row or use the dial,

A table featuring all the available loads is displayed,

Select a load value present in the table, either by touching the screen or using the wheel,

Validate the selected load by touching the screen to select the value or using the wheel,

The load value is displayed in the "EDIT" column.
Possibilities:
EDIT
SCANNED
PRESENT
REF