ADB Safegate RELIANCE Shallow Base, User Manual

Page: 34 / 46

4.4.2 Fixation of a base
Fix the Base Approximate resin consumption
1. Mix the fixing resin according manufacturer’s instructions. Estimated
value for resin consumption per base can be found in the table to the
right.
Note
The exact consumption depends on the resin type, the
installation hole dimensions, working conditions and so on. It
cannot be precisely defined beforehand.
2.
Pour the resin into installation hole. Avoid splashing it on the
alignment tool and the base.
Note
If resin used has a very low viscosity, it may need to be applied
on the bottom and walls of the installation hole before
inserting the base.
3. After pouring the resin, make sure that the base is correctly
positioned. Protruding base edges are not allowed in any
circumstances, see FAA 150/5340-30F.
4.
Wait until the resin is fully cured.
5. Remove the alignment device.
6.
Remove surplus fixing compound, for example smooth off around the
edges/sides. Remove debris in front of light so no obstruction or
threshold exists.
7. Remove the masking tape and clean inside the base.
Base type Resin consumption
Base 8” / 135 mm 1.8 liters
2, 4
Base 12” / 150 mm 3.5 liters
3, 4
Note
These resin volumes are estimated for
perfect holes and no resin waste. It is
advised to consider the actual site
requirements such as the size/depth of
each bore hole and the density/fluidity of
the resin to be used. There is also some
risk for resin waste. For more
information, see manufacturer
recommendations or as a first use
example, add 20% to the resin volume
estimate, and adjust thereafter based on
site experience.
Notes
2
Approximations are given for nominal installation hole size, Diameter Ø245 mm and depth 145 mm.
3
Approximations are given for nominal installation hole size, Diameter Ø345 mm and depth 160 mm.
4
Typical amount of resin needed with nominal installation hole dimensions. Base receptacle twin-shell construction cause lots of variation to resin
consumption because the filling rate of the cavity depends on several issues such as resin type, working method, conditions, etc.
RELIANCE Shallow Base
Installation
24
Copyright
©
ADB Safegate, All Rights Reserved