ADB Safegate RELIANCE Shallow Base, User Manual

Page: 30 / 46

Note
Find out more about the devices and installation process in the next coming pages.
Set up alignment devices
IDM 6092 (8”) and IDM 4306 (12”)
Image examples
An alignment device is used for aligning bases parallel to a center
line, toe-in bases and also for curved section bases.
The device includes:
•
Fastening screws (A).
•
Screw holes for straight sections (B).
•
Screw holes for curved sections (C).
•
Angle scale (D).
•
Alignment grooves (E).
When a base parallel to a center line or toe-in base is to be installed,
set fastening screws for screw holes for a straight section.
When a curved section base is to be installed, set fastening screws
for the screw holes for a curved section.
Figure 16: ALIGNMENT DEVICE (IDM 4306)
Set up for base installation parallel to center line and toe-in:
1.
Place the alignment device on the base.
2. Tighten the fastening screws.
3.
Set the angle scale to the desired value (0° for a parallel
to center line base) and check both scales show the same
value.
4. Tighten fastening screws.
Note
For 12” base, side access can be aimed to six different
directions depending on which index alignment tool
is set.
Figure 17: PARALLEL CENTER LINE
Set up for curved section base installation:
1. Place the alignment device on the base.
2.
Tighten the fastening screws.
Note
For 12” base, side access can be aimed to six different
directions depending on which index alignment tool
is set.
For a curved section base, align by aiming the alignment tool
towards the curve center.
Figure 18: CURVED SECTION
RELIANCE Shallow Base
Installation
20
Copyright
©
ADB Safegate, All Rights Reserved