ADB Safegate RELIANCE Shallow Base, User Manual

Page: 23 / 46

4.0 Installation
This section includes basic step-by-step instructions generally applicable for all installation practices. However the installation
steps may differ depending on site requirements. Before you start, make sure you have read and understand Safety
instructions .
An inset light fitting base uniquely defines position, orientation and level for the light unit positioned in it. These criteria are
defined during the base installation process and are almost impossible to change afterwards. For this reason it is highly
important that base installation is carried out accordingly.
4.1 Cabling options
Cabling option Image examples
For installation using saw cuts made in the layout to lead secondary
cables, use a shallow base with side entry/entries.
Note
Image example shows assembly of 12” base and
fitting but is valid for installation of 8” base and
fittings as well.
Figure 11: Saw cuts/side entry
For installation using buried conducts in the layout to lead the
secondary cables, use a shallow base with bottom entry.
Note
Image example shows assembly of 12” base and
fitting but is valid for installation of 8” base and
fittings as well.
Figure 12: Buried conducts/bottom entry
For correct light location, orientation and so on it is recommended to read and comply with the following:
•
ICAO: Annex 14 Volume I, which refers to lighting system installation in general.
•
All drawings and design plans, for the particular project, to guarantee correct location and orientation for each light unit.
The following tools and accessories are required for installation and removal of the unit:
•
Standard surveying equipment.
•
Coring and cutting equipment with diamond blades (such as for pavement surfaces).
•
Alignment device for the base.
•
Tools for electrical connection (depending on the cabling system, for example cutting/striping pliers, crimping tool, hot air
gun and the like).
•
22/24 mm fork wrench for cable gland.
•
8 mm socket wrench for a ground screw.
•
Two component fixing compound.
•
Cable groove sealer (saw cut/grooves cabling system only).
UM-0106, Rev. 1.0, 2019/12/19 13
Copyright
©
ADB Safegate, All Rights Reserved