ADB Safegate RELIANCE Intelligent Lighting Platform III, User Manual

Page: 109 / 118

Table 23: Lamp test results — legend description
State Description
All remotes — result not available Self-test has not be executed yet / test results not received
Configured modules — result ok (green check mark) Received actual value equals preset nominal value
Configured modules — result ok (green check mark) Received actual value does not equal preset nominal value
Not configured value — result ok (grey cross symbol) No feedback is received from lamps not considered to be configured
Not configured value — result not ok (red check mark) Feedback is received from lamps not considered to be configured
In the following example all five states are represented:
Figure 76: Self-test result example — different states
In this example the lamps with lamp addresses 39 and 3 are configured in the series circuit while lamp with address 44 is
not configured in the circuit. That means lamp 39 sent feedback and its state equals the nominal value while 44 cannot
send feedback as it is not configured and lamp 3 sends feedback although it is not supposed to send feedback. Lamp 3
sends feedback as it is configured although it is not assigned to the test segment.
Important
The configuration set in IL III must equal the configuration set in the circuit. If the configuration in lucDMC,
especially for segment assignment, does not equal the actual configuration in the circuit, you will not be able to
achieve to control the lamp segments you aim to control.
Tip
Use the RFID reader DRH100 to check the remote addresses assigned to the lamps.
UM-5005, Rev. 004, 2020/08/06 97
Copyright
©
ADB SAFEGATE, All Rights Reserved