ADB Safegate AXON, User Manual

Page: 32 / 88

To protect in-pavement lights from damage during the snow removal it is important that the snowplows are equipped with
plastic cutting edges.
•
The plastic cutting edge should be made of polyurethane, rubber or material of similar consistence and characteristics.
•
The plastic cutting edge should consist of a minimum of plastic segments, accurately aligned and free of steps between
them.
Figure 3: Fig. 1 - Snowplow blade with well aligned segments
•
It is not recommended to have steps between the plastic segments.
•
Vertical or horizontal steps between the plastic segments will increase the risk of luminaire damage. Hitting inset fixtures
with steps between plastic segments should be avoided.
•
Check regularly for wear and abrasion marks on plastic cutting edges.
•
The plastic cutting edges should be replaced when worn down to the wear limit marking. Wear down to the metal portion
of the plow should be avoided in any case.
Figure 4: Fig. 2 - Snowplow blade with wear and steps between segments
AXON Runway Inset Lights
Maintenance
22
Copyright
©
ADB Safegate, All Rights Reserved