Adaptrum ACRS 2.0, Quick Start Manual

Page: 42 / 64

2016.05.16 Adaptrum© P a g e 42 | 64
support@adaptrum.com All Rights Reserved Worldwide
2016
Adaptrum ACRS2.0 Quick Start Guide (International)
List
This tab is only available for the BASE.
The Link List tabulates CLIENT channel parameters and is used for
Remote Update . The list display is not
valid unless Device & Channel Update Status has been clicked at least once (or Auto Update is on).
Figure 23: GUI screenshot: Link List View
# FIELD DESCRIPTION
1 Link List Table
dynamic metrics specific to each CLIENT (the example above shows two CLIENTs);
the available metrics are listed in the table below
Table 4: Link List View Description
Note: Fields in gray font are reserved for Adaptrum diagnostic use.
# FIELD DESCRIPTION
a
Notes CLIENT System Notes from Installation tab (field #1); remote configuration [1]
b
Client SN(MAC) CLIENT unit Serial Number (MAC Address)
c
Bandwidth (D/U) Available Bandwidth (Downlink/Uplink) in Mbps
d
PHY Mode (D/U) PHY Mode (Downlink/Uplink) e.g. QAM, QPSK
e
PER (D/U) Packet Error Rate (Downlink/Uplink) in percent
f
Power (D/U) Power (Downlink/Uplink) in dBm
g
Noise (D/U) Noise (Downlink/Uplink) in dBm
h
SNR (D/U) Signal-to-Noise ratio (Downlink/Uplink) in dBm (> 30dB indicates a good link)
i
Temperature CLIENT Temperature (3 points on the PCB) in degrees C
j
SW Info CLIENT Radio Software Version (System Information field #1)
k
HW Info CLIENT Radio Hardware Version (System Information field #6)
l
Heap Size CLIENT software heap size (System Information field #3)
m Boot ID
CLIENT boot sequence number (System Information field #4)
n
ATT (min/RAS/Act) reserved parameter for Adaptrum use only
o
Timing Off 10MHz reserved parameter for Adaptrum use only
Table 5: Link List View Field Descriptions
[1] Once a link is established, CLIENTs may be remotely updated by right-clicking on the Notes field. See Remote
Update Appendix.
A
P
P
EN
D
IX