5-8
SATA Storage Enclosures (FS4100 and FS4500)
SATA I/O Module Configuration
This section describes how to configure the two I/O modules.
FS4100 I/O Module Configuration
The Adaptec FS4100 I/O module supports JBOD and does not
require configuring.
FS4500 I/O Module Configuration
Use the Spheras RAIDWatch software application included on
your Adaptec Storage Enclosure CD to configure the Adaptec
FS4500 I/O module. Refer to the Adaptec Storage Enclosure CD for
software documentation.
Drive Carrier LEDs
Each drive carrier has three LEDs that are visible from the front of
the Storage Enclosure. See
detailed information about LED functions.
D7
a
Partner
Failed
Partner controller has
failed
Partner controller
operating
properly
D8-1
Cache/BBU
Fault
■
Data in cache memory
■
Cache memory failed
■
Cache being held by
battery back-up
■
Battery not capable of
sustaining memory
■
Battery not present
Battery back-up is
capable of
sustaining
memory in case of
power loss (has
87% or more
original charge
capacity)
a
In single controller configurations, this LED is not used.
Table 5-5 FS4500 I/O Module LEDs
LED Designation
LED
On
LED
Off
