17
2
Connect the Adaptec AVC-3610 to your set-top boxes, shown in
the Figure in
as Set-top Box (A) and Set-top Box
(B).
a
Connect an RF coaxial cable from the TV1 jack on th
e
AVC-3610
to the TV Out port on
Set-top Box (A)
.
b
Connect an RF coaxial cable from the TV2 jack
on the
AVC-3610
to the TV Out port on
Set-top Box (B)
.
Caution:
Be sure not to plug an RF coaxial cable into the FM
tuner jack.
To improve video quality, you can use S-Video cables or
composite video cables instead of RF coaxial cables to make these
connections. See pages
for instructions.
3
Use two RF coaxial cables to connect the TV In ports on your
set-top boxes to the cable splitter.
4
Connect an RF coaxial cable from the cable splitter to your
TV
wall jack.
5
Connect IR blaster cables from the Adaptec AVC-3610 to your
set-top boxes. You must connect IR blaster cables to be
able to change channels.
a
Plug an IR blaster cable into the IR 1 port on the Adaptec
AVC-3610.
Then, peel the protective paper off the emitter end of the
cable and adhere it over, or as close as possible to, the
infrared lens of Set-top Box (A).
b
Repeat
to connect the IR 2 port on the Adaptec
AVC-3610 to Set-top Box (B).
6
Completing the Setup on page 25
.
!
Summary of Contents for AVC-3610
Page 1: ...Adaptec AVC 3610 Getting Started ...
Page 37: ...36 ...
