Adaptec 5325301638 - Snap Server 4500 NAS, Administrator'S Manual

Page: 128 / 148

Installing Third-Party Agent Software
114 Snap Server Administrator Guide
Installing a Legato NetWorker Client
This section describes how to install the Legato NetWorker UNIX/Linux client as
well as special procedures Legato NetWorker users must use in order to perform
backup and restore operations on the Snap Server.
To Install the Legato Networker Client
1
Connect to the Snap Server via SSH, and login as admin using your admin user
password.
2
To change to superuser, enter the following command and press
Enter
:
su -
3
At the prompt, enter the admin user password, and press
Enter
.
4
Use the
cd
command to change to the directory in the share, for example:
cd /shares/SHARE1/agent
5
To unpackage the client files, enter the following commands:
tar xvfz nw_linux86.tar.gz
cd LGTOclnt
rpm -Uvh --nodeps lgtoclnt
-x.x-x
.i386.rpm
where x.x-x is the version number.
6
To start the Legato NetWorker daemon, enter the following command at the
console:
/etc/rc.d/init.d/networker start
The NetWorker client is now installed.
7
Close the SSH client, and then return to the Administration Tool and do the
following:
a
To disable SSH on the Snap Server, navigate to the
System > SSH
screen, select
No , and then click
OK
. SSH is immediately disabled.
b
To start the newly installed backup agent, navigate to the
Maintenance >
Shutdown/Reboot
screen, and click
Reboot
.
8
Delete the client files you copied to the Snap Server because they are no longer
needed.
9
To verify the success of the installation, use your backup management software
to configure and run a test backup.