Adaptec 2130SLP - SCSI RAID Controller, Installation And User Manual

Page: 30 / 134

Chapter 4: Getting Started
●
30
Choosing a RAID Level
This section provides a brief overview of the RAID levels supported by
your Adaptec RAID controller, including the minimum and maximum
number of disk drives required by each.
Note:
RAID 1E, RAID 5EE, RAID 6 and RAID 60 are available in the
upgrade package. (See page 20 .) For more information about RAID
levels, see Understanding RAID on page 79 .
●
RAID 0 (Non-redundant Array) —Stripes data across multiple disk
drives. Improved performance but no redundancy (see page 80 ).
●
RAID 1 Array —Created from two disk drives where one disk drive
is a mirror of the other (the same data is stored on each disk drive).
Redundancy, but reduced capacity (see
page 81 ).
●
RAID 1E Array —Similar to a RAID 1 array except that data is mirrored
and striped, and more disk drives can be included (see page 82 ).
●
RAID 5 Array —Stripes data for improved performance and uses
parity data to provide redundancy (see page 84 ).
●
RAID 5EE Array —Similar to a RAID 5 array, but includes a distributed
spare and must include a minimum of four disk drives (see page 85 ).
●
RAID 10 Array —Built from two or more equal-sized RAID 1 arrays,
stripes and mirrors data across multiple disk drives. Redundancy
and improved performance (see
page 83 ).
●
RAID 50
1
Array —Built from multiple disk drives configured as two
or more RAID 5 arrays, stripes stored data and parity data across all
disk drives (see
page 86 ).
●
RAID 6 Array —Similar to a RAID 5 array except that it includes two
independent sets of parity data instead of one (see page 87 ).
●
RAID 60
*
Array —Similar to a RAID 50 array except that it includes
four independent sets of parity data instead of two (see page 88 ).
Use the table on page 89 to see how many disk drives you must connect
to your RAID controller to support the RAID level you want.
1
Because it supports four disk drives only, the Adaptec 2420SA RAID controller can’t
support RAID 50 or RAID 60.