2-2
Adaptec Ultra320 SCSI Cards User’s Guide
Using SCSI Devices
If you connect SCSI devices (such as scanners, tape drives, zip
drives, etc.) to your Adaptec SCSI Card, you must install the device
manufacturer’s proprietary software drivers. See your device’s
documentation for details.
Using SCSI Hard Disk Drives
■
If you connect a SCSI hard disk drive to an Adaptec SCSI Card
that was previously connected to a different SCSI card, it is
recommended that you low-level format the drive before you
use it. Back up the data on the drive before moving the drive to
the new SCSI card and before you format the drive. (See
SCSI Disk Utilities on page 3-16
for information on using the
SCSISelect format utility.)
Caution:
A low-level format destroys all data on the drive.
Be sure to back up the data before performing a low-level
format.
■
Every SCSI hard disk drive must be physically low-level
formatted, partitioned, and logically formatted before it can be
used to store data. Most SCSI drives are preformatted at the
factory. If your SCSI hard disk drive has not been preformatted
at the factory, and if your computer is running under DOS, you
can prepare the disk with the DOS
Fdisk
and
Format
commands. (See the DOS and Windows documentation for
more information.) To format SCSI hard disk drives running
under other operating systems, see the operating system
documentation.
!
U320 UG.book Page 2 Tuesday, September 23, 2003 1:47 PM
