9-5
Installing the SCSI Driver for Windows NT 4.0
Using Advanced Configuration Parameters
Advanced users may use software parameters to alter the
configuration of the Windows NT 4.0 device drivers supplied by
Adaptec. For more information on using advanced configuration
parameters, see
Appendix C, Using Windows Advanced
Hot-Plug PCI Support
Hot-Plug PCI is supported by the Windows NT 4.0 driver
adpu320.sys
.
Warning:
You will need a system that supports Hot-Plug PCI
as well as associated Hot-Plug PCI application software in
order for Hot-Plug PCI to work. Do not enable the Hot-Plug
PCI feature unless your system is Hot-Plug PCI capable and
you wish to use the Hot-Plug PCI feature. For more
information on Hot Plug PCI, refer to your motherboard or
system documentation.
To enable Hot-Plug PCI support in the driver:
1
Insert the Adaptec Installation CD into drive
D
.
2
Select Run from the Start menu.
3
Type the following, then press Enter:
d:
\packages\FMS\Windows\driver\winNt40\
hotp320.reg
4
Click OK.
5
Restart your computer.
U320 UG.book Page 5 Tuesday, September 23, 2003 1:47 PM
