When removing the inboard plastic coverings, use a trim tool to gently remove the plastic sill piece, leaving the ACURA
sill plate intact. After removing that piece, carefully remove the plastic, making sure you do not damage any clips.
Once you have fully removed the plastic, gently snap the piece back into place and pull the blue tape from the silver sill
plate. If there is any remaining residue from the adhesive tape, gently remove it with a clean shop towel and some
adhesive remover.
4.
Install the Left-Side Shift by Wire (SBW) Shifter Trim
Install the left-side SBW shifter trim onto the SBW shifter assembly as shown. Make sure it clicks into place.
NOTE
The glove box will not open unless the No. 15 BACK UP RADIO (10 A) and No. 16 BACK UP (10 A) fuses are installed.
Page
6
of
15
