Acuity AccuRange AR2700, User Manual

Page: 33 / 33

AR2700 User’s Manual 27
8. Serial Command Quick Reference
Type <Enter> after each command.
AR2700 Configuration Data Settings (Serial)
Factory
Default
Command Name
Serial
Command
Serial Code / Function
Identification ID Displays sensor identification information
Online help menu ID? Displays serial command menu
Distance Tracking DT Continuous measurements DT
Single Distance
Measurement
DM Serial trigger for a single distance measurement
Temperature Query TP Queries internal sensor temperature in °C
Hardware Status HW Reports hardware info for error handling
Parameter Display PA Lists all parameters with current settings
Factory Reset PR Resets all parameters to factory default values EXCEPT baud rate
Device Reset DR Simulates a power restart of sensor SA1
Autostart configuration ASx
Configures which modes and parameters will become active after power
up
ASDT
Measurement Frequency MFx Adjusts the sampling frequency from 1 to 16000 MF10000
Averaging Value SAx
Sets the number of samples to be averaged before transmitting
measurement
SA1000
Measurement Window MWx y z Sets a specified measurement window
MW-71.000
71.000 0
Distance Offset OFx Adds the offset value to the measurement OF0.000
Current Distance Offset SO Sets the current measurement to the offset value OF
Error Mode SEx Sets the error mode behavior for Analog and Alarm interfaces SE1
Alarm Output 1 Q1w x y z Sets the threshold, range, hysteresis and state for alarm
Q10.000
1.000
0.050 1
Alarm Output 2 Q2w x y z Sets the threshold, range, hysteresis and state for alarm
Q20.000
1.000
0.050 1
Analog Settings QAx y Sets the beginning and end points for the 4-20mA interface
QA0.000
1.000
Baud rate BRx
9600 BR9600<Enter>
19200 BR19200<Enter>
115200 BR115200<Enter>
230400 BR230400<Enter>
460800 BR460800<Enter>
921600B R921600<Enter>
1843200 BR1843200<Enter>
2000000 BR2000000<Enter>
BR115200
Serial Data Format SDx y
Configures the serial data format from ASCII decimal, hexadecimal or
binary and also if range, temperature and measurement strength are
transmitted
SD0 0
Terminator character TEx Selects the ASCII line terminator (CR LF, CR, etc.)
TE0
(CR LF)
Select Target STx Selects the target the sensor follows. ST0
Trigger Input TIx y Enables and sets the reaction of the sensor to a trigger signal. TI0 0
Trigger Output TOx y Enables and characterizes the output trigger signal. TO0 0
Gain GNx Allows for the adjustment of signal amplification GN0
Time Calibration TCx Self corrects for measurement drifts every x seconds. TC1