Acuity Brands | One Lithonia Way Conyers, GA 30012 | Phone: 800.535.2465 | www.acuitycontrols.com | © 2019 Acuity Brands Lighting, Inc. | All rights reserved. | Rev. 11/14/2019
o
Allow for proper clearance around the device’s enclosure and wiring terminals to
provide easy access for hardware configuration and maintenance.
o
Orient the device with the ventilation slots towards the top to permit proper heat
dissipation.
•
Should not be installed on an exterior wall.
•
Should not be installed near a heat source.
•
Should not be installed near an air discharge grill.
•
Should not be installed in a place where it can be affected by the sun.
•
Install in an area that provides proper device ventilation. Nothing must restrain air circulation to
the device.
The nLight® UNITOUCH is not designed for outdoor use.
Installation Instructions
Upon unpacking, inspect the contents of the carton for shipping damages. Do not install a
damaged device.
Take reasonable precautions to prevent electrostatic discharge to the device while installing, servicing or
during operation. Discharge accumulated
static electricity by touching one’s hand to a well
-grounded object
before working with the device.
For proper installation and subsequent operation of the device, pay special attention to the following
recommendations:
1.
Turn circuit breaker to
OFF
position, or remove fuse(s), and test that power is off before installation process.
Never wire any electrical device with power turned on. Wiring while
HOT
may cause permanent damage to
this device and other equipment and void warranty.
2.
Remove the front cover of the device from the mounting plate:
a.
Remove the security screw
b.
Using an appropriately sized tool, press in the two (2) release tabs on the sides of the device and
pull the front cover out from the bottom. See
Figure 3
for security screw and release tab
locations.
3.
Pull all cables 6” (15cm) out of the wall and insert them through the central hole of the back
plate.
4.
Make sure that the mounting surface is flat and clean.
5.
Screw the back plate onto the electrical junction box.
6.
Plug the wire(s) into the connector(s). Gently push excess wiring back into the wall.
7.
Reattach the front plate and make sure it clips tightly into place. Tighten the security screw.