Acuity Brands | One Lithonia Way Conyers, GA 30012 | Phone: 800.535.2465 | www.acuitycontrols.com | © 2019 Acuity Brands Lighting, Inc. | All rights reserved. | Rev. 11/14/2019
Installation
The nLight® UNITOUCH is equipped with two RJ-45 ports for CAT5 connection to other nLight-enabled devices as
well as a set of polarity insensitive power terminals for low voltage power.
Wiring Recommendations
A 15-24 VDC or VAC power supply can deliver power to the nLight UNITOUCH via the polarity insensitive terminal
connections on the back of the unit. The PS 150 version power supply (included in the KIT option) is recommended, as it
conveniently mounts through a knock-out on the back of the junction box where the unit is positioned.
Risk of Electric Shock:
Turn off power before any kind of servicing to avoid electric shock.
•
Comply with all network and power supply guidelines outlined in the Network Guide.
•
Use the screws, wall anchors, and wire nuts included for wall mounting and wiring.
•
All wiring must comply with electrical wiring diagrams as well as national and local electrical codes.
•
We recommend using CAT5 cable to connect the nLight® UNITOUCH to the controller.
Figure 2- Wiring Diagram (Power)
Mounting Instructions
The nLight® UNITOUCH has been designed for ease in installation; However, certain conditions
must apply when choosing a suitable location for the device. These include:
•
Install in a location approximately 5 ft (1.5 m) above the floor
•
I
nstall approximately 6” (15cm) from a corner
in order to provide sufficient access to the
faceplate release tabs.
RJ-45 nLight
Network Ports
Low-Voltage Terminals
(15-24VDC, 40mA)
3.37
”
[85.5mm]
0.75”
[19mm]
0.2”
[5mm]
0.83”
[21mm]
0.2”
[5mm]
0.2”
[5mm]
0.28”
[7mm]
0.28”
[7mm]
0.4”
[10mm]
2.20”
[56mm]
2.28”
[58mm]
3.23
”
[82mm]
Figure 1- Device Information