Quick Start Guide
SC 4202/L
© 2018 eldoLED. All rights reserved. V1.1 All content contained herein is subject to change without prior notice.
More product documentation and eldoLED´s terms and conditions are available at www.eldoLED.com
Safety
Before installing or performing routine maintenance upon this equipment, follow the general precautions listed in this section.
WARNING: RISK OF ELECTRIC SHOCK
-
May result in serious injury or death. Disconnect or turn off power before installation or maintenance.
-
The device may only be connected and installed by a qualified electrician. All applicable regulations,
legislation and building codes must be observed. Incorrect installation of the device can cause
irreparable damage to the device and the connected LEDs.
-
Verify that supply voltage is correct by comparing it with the product information.
-
Make all electrical and grounded connections in accordance with all applicable local code
requirements.
WARNING: RISK OF BURN OR FIRE
-
Do not exceed maximum wattage, ratings, or published operating conditions of product.
-
Do not overload.
-
Follow all manufacturer’s warnings, recommendations and restrictions to ensure proper operation of
product.
CAUTION: RISK OF DAMAGE DUE TO ESD
-
Electrostatic Discharge (ESD) can damage product(s). Personal grounding equipment must be worn
during all installation of the unit.
-
Do not touch individual electrical components as this can cause ESD and affect product performance.
CAUTION: RISK OF PRODUCT DAMAGE
-
Pay attention when connecting the LEDs: polarity reversal results in no light output and often
damages the LEDs.
-
Do not stretch or use cable sets that are too short or are of insufficient length.
-
Do not tamper with contacts.
-
Do not modify the product.
-
Do not change or alter internal wiring or installation circuitry.
-
Do not use product for anything other than its intended use.
-
Do not install damaged product! This product has been properly packed so that no parts should have
been damaged during transit. Inspect to confirm.
