ACU-RITE MILLPWR G2, Technical Manual

Page: 449 / 546

6.8 Override 449
6.8 Override
6.8.1 Override Devices
The control supports the following override devices:

Up to two potentiometers

Group of keys (You can use two machine operating keys for setting the over-
ride value.)
The input values of the override devices (potentiometer setting or key input)
are evaluated as follows:

DISCRETE: The control converts the input values into a maximum of 64 dis-
crete override values.

LINEAR: The control interpolates the input values linearly between the min-
imum and maximum override value.

CURVE: The control uses a curve to convert the lower input values into over-
ride values. In this way you can achieve a finer resolution of the lower over-
ride values. Higher input values are again interpolated linearly.
Define the override devices as follows:
 Define the override device in MP_source.
 In MP_mode, define the evaluation of the override input.
 In MP_values, define the discrete override values or the interpolation points
of the curve.
Settings in the configuration editor:
System
PLC
CfgPlcOverrideDev
Key for override device
source
mode
values