SETUP
Install or Replace Battery
AcuRite recommends high quality
alkaline batteries for the best product
performance. Heavy duty or rechargeable
batteries are not recommended.
1
2
Slide the battery compartment cover
open and install 1 fresh “AA” battery.
Follow the polarity (+/-) diagram in the
battery compartment.
Replace battery cover.
Select Temperature Units
To select between degrees Fahrenheit (°F) or Celsius (°C) temperature units,
slide the “°F/ °C” switch located inside the battery compartment located on
the back of the display.
Set the Time
To set the time, slide the “SET TIME” switch to “SET TIME”. The time will now
blink. Adust the hours by pressing the “+ HOUR” button. Adjust the minutes by
pressing the “+ MINUTE” button. When you have reached the desired time,
slide the “SET TIME” switch away from “SET TIME”.
1
2
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fre,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
OPERATION
Placement for Maximum Accuracy
AcuRite sensors are sensitive to surrounding environmental conditions. Proper
placement of both the display unit and temperature probe are critical to the
accuracy and performance of this product.
Display Unit & Probe Placement
Place the display unit in a dry area free of dirt and dust. Display unit stands
upright for tabletop use or is wall-mountable.
To observe outdoor temperatures, the wired temperature probe must be placed
outside. The probe sensor can be securely mounted to a surface utilizing the
adhesive pad or the integrated hang hole. Take care not to damage the probe
during mounting.
4
