http://www.advancedactuators.com
ReliTouch® User Manual
53
Section 2 Administrator and User Setup
NOTES:
Fingerprint User IDs 1-3 are Administrators, meaning that they
have complete access to program the ReliTouch
®
RT-201
and to
unlock the door at any time.
To access any menu options, after an Administrator fingerprint
has been enrolled, the Administrator’s fingerprint will need to be
verified after pressing “M” to enter the menu options.
The term “Fingerprint” is used as a general term when
describing fingers or thumbs to use for enrollment/verification.
Before enrolling and verifying fingerprints, make sure to read the
following helpful hints for Fingerprint Enrollment and
Verification
:
Generally, the center of the vortex (swirl) of the fingerprint pattern is
the key data point;
ideally, it is placed in the center of the sensor’s
glass window in a consistent way
.
Your finger or thumb should
be flat, motionless and held with light pressure in the same way
each time. See the picture below for some guiding drawings.
Also, be sure that your fingerprint is well defined, where you can
visibly see the well defined peaks and valleys of the vortex ridge
pattern.
Light pressure when placing the finger or thumb on the scanner gives
the best image, but the finger must not move during scanning.
Adjust Fingerprint Sensitivity settings per
Section 1.3
.
www.BuilderDepot.com
