1.
Place vehicle in
Park
(automatic transmission) or
Neutral
(manual transmission), set
parking brake
and block drive
wheels.
To avoid damage to ignition system circuits or other circuits related to or connected to ignition
wiring, follow all vehicle service manual instructions for disabling ignition system.
2.
Follow vehicle service manual to disable ignition system.
Use EXTREME CAUTION when connecting starter switch. Battery voltage is present at
solenoid or relay and damage or injury can occur from shorting the leads.
Follow all vehicle service manual instructions on how and where to connect Remote Starter
Switch. ONLY connect Starter Switch to starter relay or solenoid. If switch is connected
improperly, wires may become warm. If wires become warm, do not continue to push start
button, as damage to Starter Switch may occur.
3.
Connect Starter Switch as stated in vehicle service manual.
4.
Turn vehicle ignition switch to the ON position.
MAKE SURE HANDS AND STARTER SWITCH WIRES ARE AWAY FROM ALL BELTS AND
FANS.
5.
Press
START
button on Starter Switch to crank engine.
After disconnecting Starter Switch, reconnect all leads and connectors that were disconnected to disable
the ignition system.
SAFETY GUIDELINES
Always
wear eye protection.
Always
operate vehicle in a ventilated area.
Always
keep people, tools, and test equipment away from moving and hot engine parts.
Always
make sure vehicle is in
Park
(automatic transmission) or
Neutral
(manual transmission) and
parking brake
is set.
Always
block drive wheels on vehicle.
Always
keep a fire extinguisher for gasoline/electrical/chemical fires near by.
Always
turn ignition key OFF when connecting or disconnecting electrical components, unless otherwise instructed.
Always
keep away from vehicle fans.
Always
follow vehicle manufacturers warnings, cautions, and service procedures.
Never
lay tools on vehicle battery.
Never
smoke or have open flames near vehicle.
Never
leave vehicle unattended while running tests.
USING STARTER SWITCH
HEAVY DUTY STARTER SWITCH
(WITH HOT CIRCUIT INDICATOR LIGHT)
!
CAUTION
!
CAUTION
!
CAUTION
!
WARNING
IMPORTANT
The Heavy Duty Starter Switch With Hot Circuit Indicator Light is used to remotely operate starter on vehicles equipped
with a starter solenoid. The Starter Switch has an added feature of a red light that glows when the starter switch is
connected to a hot circuit and goes out when the button is pressed. This is a helpful indicator that tells when the Starter
Switch is ready to use.
