actiLib Library 4U
– User and Service Guide
Page 92 of 103
9.7
Removing and replacing a magazine using the OCP
CAUTION
The magazine must only be removed manually in an
emergency. Failure to follow normal procedure can
cause data loss and equipment damage.
The magazines should be released using the Operator Control Panel (OCP) or the Remote
Management Unit (RMU). Recommends that you release the magazine using the OCP or RMU,
however, if the OCP process fails, or if the magazine needs to be removed when the power to
the tape Library is off, you can manually release the magazines.
This OCP option lets you gain access to the left and right magazine. Access to the magazines
requires the use of the Administrative password.
To remove a magazine:
1.
From the Home screen, press
“Previous” or “Next” on the OCP until the screen displays
Operations.
2.
Press
“Enter” to select.
3.
Press
“Up” or “Dawn” until the screen displays either Unlock Left Magazine, or Unlock
Right Magazine.
4.
Press
“Enter” to select the desired magazine to unlock.
5.
“Enter” the Administrative password if requested.
6.
The display will read Left Magazine Unlocked, or Right Magazine Unlocked.
7.
Pull the released magazine out of the Library.
8.
The screen will now display Insert Left Magazine, or Insert Right Magazine. The Library
cannot perform any other operation until the magazine is replaced. After exchanging tapes
in a magazine, slide the magazine completely into the Library. The magazine will lock into
place once it is correctly installed and the Library will inventory the magazine.
Summary of Contents for actiLib Autoloader 4U
Page 40: ...actiLib Library 4U User and Service Guide Page 40 of 103 Figure 24 Interaction Mode Commands ...
Page 43: ...actiLib Library 4U User and Service Guide Page 43 of 103 Figure 27 Interaction Mode Service ...
Page 60: ...actiLib Library 4U User and Service Guide Page 60 of 103 Figure 40 Configuration license key ...
