TCM-7411 Hardware User’s Manual
Physical description
1) Ethernet Port
The IP device connects to the Ethernet via a standard RJ45 connector. Supporting NWAY, this IP
device can auto detect the speed of local network segment (10Base-T/100Base-TX Ethernet).
2) Power Input
Connect the power adaptor here if your power input is DC12V.
3) Digital Input / Output & Audio Terminal Connector
This IP Camera supports DI/O & Audio input / output via terminal block.
Used in applications like motion detection, event triggering, time lapse recording, alarm
notifications, etc., the I/O terminal connector provides an interface to respective devices. The
Terminal Block wiring diagram is as follows:
PIN
NAME
DESCRIPTION
1
12V
DC Power Input
2
GND
Ground Pin
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
