ACTi R12CP-30, Installation Manual

Page: 17 / 20

www.acti.com
Installation Guide
17
Quick Setup
Enter Setup Mode
Enter Setup mode if you need to change any of the settings or add users to the device.
To enter setup mode, press
1 2 3 4 5 6
. 123456 is the default master code; to
modify the master code, see How to Change the Master Code on page 18.
Initial Setup
Change the Language
The default device interface language is English, to change the language:
1. Press
1 2 3 4 5 6
2. Press
5
[Tools]
 1
[Language]
3. Press either
0
[English] or
1
[Chinese]
Configure the IP Address
The default IP address of the device is:
192.168.0.100
You can modify the static IP address or enable DHCP mode to obtain automatically obtain an IP
address if it is connected to a DHCP server.
Modify the IP Address
To modify the static IP address, do the following:
1. Press
1 2 3 4 5 6
2. Press
3
[Parameters (1)]
 1
[Node ID]
3. Press four (4) times to scroll through the submenu option until you see ENABLE
DHCP on the screen.
4. On the ENABLE DHCP screen, press
0
to select static address.
5. Press the keypad to enter the preferred IP address.
TIP: Press to enter or copy the existing value shown on the screen.
6. Continue to enter the Net Mask , and Gateway .
7. When done, press to exit the configuration menu.