www.acti.com
Hardware Manual
19
Connecting DI/DO Devices (Optional)
Depending on your surveillance needs, you may connect digital input/output devices, such as
a door relay or alarm, to the camera.
Check the device documentation for the pin mapping specifications. Map the pins of the device
to the terminal block pins accordingly. Press and hold the orange tab as you insert the wire
through the pin slot, then release the orange tab to secure the wire. Then connect the terminal
block to the camera.
Below is a diagram on how the Digital Output / Input of the camera work.
Using Door Locks with Internal Switch
Below is an example on how to integrate a door lock with internal switch/latch, like
PLOC-0001
door lock to the door station; once an RFID card is read, the door lock will open.
Note:
PLOC-0001 is not included with the door station package but available for purchase.
1.
Install the door lock as indicated on its installation guide.
2.
Adjust the DIP switch on the door lock to set the
amount of time wherein the bolt will lock after it has
been opened. The image below shows the door
lock is set to
3-sec
.
(COM)
