ENR-
100 Series System Administrator’s Manual
Disk Management
ENR keeps the recordings on SATA hard disks installed in it. Whenever recording is taking
place, ENR writes data to one of the disks, and switch to the other as the original one is full.
Once the available space of the whole system is less than the reserved size, ENR will start
deleting the oldest file to make the amount of space allowing each active channel to record
for another 10 minutes.
You may observe the disk memory and recording status on
Storage
page.
On
Live
screen, click
Setup
click
System
tab
click “
Storage
”. The connected storage
devices will be shown in the
Storage Device
list. Select a storage device to check its
Storage
Information appearing as below.
Storage Device Types
●
SATA1
represents the disk installed in upper bay for saving recordings.
●
SATA2
represents the disk installed in lower bay for saving recordings.
●
Storage Media
represents the connected USB disk that you inserted for carrying
firmware image file, backup file, exported system log file, snapshots or video.
