31
GLOBAL REMOTE CONTROL (PAC-204RC)
DISPLAY SECTION
A
[Current/start/ending time] Display
B
Operation mode
Displays the status of operation.
C
[Checking] Display
This display appears when abnormality
occurs in the unit.
D
[Set temperature] Display
Displays the set temperature.
E
[Operation] Lamp
Lights up during operation, goes off during stop.
F
[Room temperature] Display
Displays the temperature of the air sucked in
during operation.
G
[Fan speed] Display
To indicate High-speed or Low-speed.
H
[Key lock] Display
This display appears when key lock function is active.
BEFORE STARTING OPERATION
* Make sure that the power supply is turned ON before use. (Keep the power supply turned ON at all times
when the air conditioner is in use. Use of the unit without power can result in compressor failure.)
WARNING:
Check and confirm the power circuit before use. For the contents, refer to the previously described chapter
[Crucial points to be observed for safety].
START AN OPERATION
À
Press the [ON/OFF] button Operation lamp
lights up and operation starts.
STOP AN OPERATION
À
Press the (ON/OFF] button again
Operation lamp goes off and operation stops.
•
Once the buttons have been set, pressing of the [ON/OFF] button
only can repeat the same operation thereafter.
•
During operation, the operation lamp above the [ON/OFF] button
lights up.
CAUTION :
Even if the operation button is pressed immediately after the operation is once stopped, operation is
not restarted for about 3 minutes. This function protects the machine. It automatically starts operation
after the lapse of approximately 3 minutes.
For purposes of explanation, all the displays on this page are shown in
their lit condition. This configuration does not occur in the actual unit.
1-1 ON/OFF
12. OPERATION