-27-
Document Name
AI7688H
Reference Manual
Version
V 2.0
Date 2019/08/08
Step 2: Restart the Wi-Fi driver for activating the configuration
Type the command in the system console:
wifi_mode sta
Notice
: if you use SSH to connect to the system console of AI7688H, you'll lose
the connection once the Wi-Fi command is set. This command will restart the
Wi-Fi driver. After the Wi-Fi restarts, connect your PC to the same wireless
router as AI7688H did. Then you can connect to AI7688H with mylinkit.local by
SSH again.
You can also refer to the LED behavior to check the states of the connection in
Station mode.
Step 3: Check for Internet connection
Now we can check if you’ve established Internet connection by typing the
following command in the system console:
ping –c 5 www.mediatek.com
6.3
Switch to AP mode
Step1: type UCI command to disable Station mode
wifi_mode ap
uci set wireless.sta.disabled=1
uci commit
Step 2: Restart the Wi-Fi driver
wifi
After the Wi-Fi driver restarts, the PC should be able to scan the AI7688H AP as
shown in the video of the
section.
Also the Wi-Fi status can be checked through the
