ACS Alcolock WR2, Instruction Manual

Page: 11 / 23

C
ALIBRATION
S
TATION
–
I
NSTRUCTION
M
ANUAL
7
7.4 Inspecting the aquarium air pump
Unpack the aquarium air pump and check for physical damage. Check the electrical connector. Check that the aquarium air
pump power rating conforms to the local supply rating. Plug into an AC outlet. Check for normal air pump functionality.
7.5 Inspecting the power supply
The power supply is an ACS provided part, but a locally purchased unit could be employed. The power supply must provide
sufficient current for successful operation of the Auto-Cal station, or it can lead to Handset pump failures. 14amp output is the
minimum.
8.0 Detailed operation
8.1 ALCOSIM breath alcohol simulator
ATTENTION! Note the following before adding solution to the ALCOSIM simulator:

Ensure that the ALCOSIM simulator is unplugged and switched off until instructed

Ensure that the CS is switched to “pump disabled” and is disconnected from a power source until instructed

Ensure that the power supply is disconnected until instructed

If the ALCOSIM was powered on, wait 15 minutes for the components to cool off before removing the top housing

Never open the ALCOSIM top housing when the simulator is switched on or plugged in

Failure to follow these instructions may result in injury or may damage the devices
Preparation of the ALCOSIM simulator is critical to successful and repeat calibrations, and departure from even minor details
can create extra work. The following steps are required to ensure correct operation.
1. Disassemble the solution jar from the top housing by turning the top housing counter clockwise.
2. Clean ALCOSIM jar.
3. Add a new 50 mg/dL solution into the ALCOSIM jar, filling to (but not above) the fill line marked midway up the jar.
4. Note batch number and serial number of solution used.
NOTE: Keep the empty bottle to input to the WR2 .