Acrosser Technology AND-EL6KE1, User Manual, Page: 29 / 42

AND-EL6KE1
29 www.acrosser.com
• Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit. Communication with slow devices may require
more than 1 stop bit.
• Flow control
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a ‘stop’ signal can be sent to stop the data flow. Once the
buffers are empty, a ‘start’ signal can be sent to re-start the flow. Hardware flow
control uses two wires to send start/stop signals.
• VT-UTF8 Combo Key Support
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals.
• Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal data.
• Resolution 100x31
Enables or disables extended terminal resolution.
• Putty KeyPad
Select FunctionKey and KeyPad on Putty.
3.4.8. Power Management
• Power Mode
Select power supply mode.