XVME-6500
USER
’S MANUAL
Acromag, Inc. Tel: 248-295-0310
- 26 -
http://www.acromag.com
- 26 -
www.acromag.com
•
SMBUS
–
This I2C-compatible System Management Bus has
connections to the memory DIMMs, the XMC connectors, and also
to an onboard EEPROM for module identification.
3.5 System Memory
The XVME-6500 has
two 204‐pin, right‐angle SO‐DIMM sockets (J1, J
2) to
accept DDR3L ECC SDRAM modules. At least one SDRAM module is required
to make the system operational. Note that ECC (x72) SODIMM modules are
required. Non-ECC modules (x64) are not supported. Two 8GB DDR3 SDRAM
modules are included on the standard model.
Support for the following features is provided by the system memory
interface:
•
DDR3 SDRAM with transfer rates of 1600 MT/s
•
1 GB, 2 GB, 4 GB, and 8 GB DDR3 SDRAM densities
•
72-bit wide channels (64-bits plus 8 bits of ECC)
3.6 Video
3.6.1 VGA
The XVME-6500 uses the Intel® Lynx Point controller to support the analog
VGA interface.
The VGA interface features include:
•
Integrated 180 Mhz
24‐bit RAMDAC
•
Support for analog monitor resolutions up to 1920x2000 @60 Hz
The VGA port is available on either the front panel's 26-pin connector, or via
the rear VME P2 connector. Only one port may be used at a time. It should
auto-switch when a monitor is plugged in, but if it does not it can be
configured with
DIP switches SW2-3 & SW2-4.
3.6.2 Digital Display Interfaces
The DVI-D port, available on the rear VME P2 connector, will support the
connection of either an HDMI or DVI display device. It can support 2.97 GT/s,
with resolution up to 4096x2304 at 24 Hz or 2560x1600 at 60Hz using single-
link HDMI, and up to 1920x1200 at 60Hz using single-link DVI.
The processor supports High-bandwidth Digital Content Protection (HDCP) for
high-definition content playback over digital interfaces.
The processor also integrates a dedicated Mini HD audio controller to drive
audio on an HDMI connection. The HD audio controller on the PCH would
continue to support down CODECs, and so on.
