MiniPuck Model ST132-06x0 Two-Wire TC/mV Transmitter
________________________________________________________________________________
______________________________________________________________________________________
Acromag, Inc. Tel:248-295-0880 Fax:248-624-9234 Email:
23
Message Bar
The system message bar at the bottom of the screen will display & repeat
prompt instructions as you step through calibration. It also displays
diagnostic messages. For example:
“No devices found”
“Connect a ST13x to a USB port.”
“Select a device from the drop-down box above.”
“Unable to read from the device.”
“Interface Configured”
“Sending configuration, this takes several seconds.”
“Error encountered while sending configuration.”
“No error encountered while sending configuration.”
“Getting configuration, this takes several seconds.”
“Error encountered while reading configuration.”
“No error encountered while reading configuration.”
“No error encountered on read of input.”
“Error encountered on read of input.”
“Calibrating input zero, this takes several seconds.”
“Error occurred during calibration, try again.”
“Calibration successful.”
“Calibration cancelled.”
“Calibrating input full scale, this takes several seconds.”
“Calibrating output zero, this takes several seconds.”
“Calibrating output full scale, this takes several seconds.”
“Restoring factory calibration.”
“Error occurred during calibration restore, try again.”
“Restore successful”
“Restore cancelled”
“Restoring to “Out-of-Box” condition.”
“Error occurred during restore, try again.”
“”Out-of-Box” restore successful.”
“”Out-of-Box” restore cancelled.”
“Resetting ST13x.”
“Reset complete.”
CONFIGURATION
STEP-BY-STEP
Other Configuration
Controls