Page 1 of 2
SPRINT 1.5 SURFACE-MOUNTED AERATOR
MAINTENANCE SCHEDULE
Water Treatment
The
Acqua & Co.
SPRINT 1.5 surface-mounted aerator is a high efficiency machine designed to allow
continuous operation in outdoor ponds and lakes. Due to its short motor shaft design and effective sealing
arrangement, the SPRINT 1.5 has a low maintenance requirement.
However, it is important to provide effective preventative maintenance to ensure a long life from the aerator.
It is recommended that an inspection of the primary seal is performed yearly, with inspection of the
secondary seal and bearings performed every two years. It is recommended that the maintenance
schedule provided be followed, using only genuine
Acqua & Co.
spare parts, to ensure effective
management of your asset.
Annual (Yearly) Maintenance
Annual maintenance is required to inspect the condition of the mechanical seal and clean the unit. Please
refer to
Acqua & Co.
Aeratore Sprint 1.5 hp 1
o
ed. 04/05 Diagram and Spare Parts List for reference as
required.
a) Remove and inspect propeller (Part No. 23) by removing cap (Part No. 56) and screw (part no. 89).
b) Drain paraffin oil from motor casing by removing plug (Part no. 95).
c) Remove front flange (Part No. 18) and inspect mechanical seal (Part No. 47) and insulation tube (Part
No. 52) on rotor. The mechanical seal should be inspected to ensure that there are no scratches or
marks on the carbon face or stationary face. The insulation tube should be examined for marking and
scoring. Replace parts as necessary.
d) Reassemble all parts ensuring oil is added in the zone between the central housing (Part No. 17) and
the front flange (Part No. 18). O-ring (Part No. 51) is to be replaced on reassembly. Oil to be used is
Medicinal Paraffin Oil Light, Food Grade.
e) Clean floats and motor to remove all algae, barnacle, and other build-up before returning unit to
service.