background image

TECHNICAL ASSISTANCE TOLL FREE TELEPHONE NUMBER

1.800.591.9360

TECHNICAL ASSISTANCE FAX: 1.626.855.4894

WWW.ACORNSAFETY.COM

 

 

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS

 

 

 

 

P.O. BOX 3527
CITY OF INDUSTRY, CA 91744-0527

UNITED STATES OF AMERICA

ACORN SAFETY

Models S0000-AL3

LIMITED WARRANTY

UNITED STATES AND CANADA

Acorn Safety warrants that its products are free from defects in material or workmanship under normal use and 
service for a period of one year from date of shipment. Acorn's liability under this warranty shall be discharged solely 
by replacement of repair of defective material, provided Acorn is notified in writing within one year from date of 
shipment, F.O.B. Industry, California.

This warranty does not cover installation or labor charges and does not apply to materials, which have been 
damaged by other causes such as mishandling or improper care or abnormal use. The repair or replacement of the 
defective materials shall constitute the sole remedy of the Buyer and the sole remedy of Acorn under this warranty. 
Acorn shall not be liable under any circumstances for incidental, consequential or direct charges caused by defects in 
materials, or any delay in the repair or replacement thereof. This warranty is in lieu of all other warranties expressed 
or implied. Product maintenance instructions are issued with each unit and disregard or non-compliance with these 
instructions will constitute an abnormal use condition and void the warranty. Stainless steel must be protected on job 
sites during construction and must be properly maintained after the water has been introduced into the safety product 
or Acorn's warranty is void.

3. Check your installation for compliance with plumbing, electrical, ANSI Z358.1 and 

other applicable codes.

1. Please leave this documentation with the owner of the fixture when finished.

2. Please read this entire booklet before beginning the installation.

NOTES TO THE INSTALLER:

  

Acorn Safety

 

a division of Acorn Engineering

Manual #7109-305-001

Revised: 12/10/18

Summary of Contents for S0000-AL3










Reviews: