ACOM 2100 Transformer Installation
C A U T I O N
After installing the transformer, the weight of the unit is about
30kg, which should preferably be handled by two persons. An
assistant may be needed to hold the amplifier steady during
transformer installation.
Position the amplifier, with the transformer not yet installed, flat on a table near
the place where it will be used. During the process described below, when the
amplifier cover is removed, take care not to torque or twist the chassis nor let
the amplifier stand on edge. Do not lift the unit by only one corner.
Remove the cover by removing all nine M3x6 screws.
Orient the amplifier on the table so that the transformer compartment is in front
of you.
Unplug all five connectors from the Mains board and remove two M3x8 screws
and one M3x6 screw.