ACOEM Met One Instruments GAS-1060, User Manual

Page: 75 / 164

Communications Page 75
Figure 26 – New Station Connection
Table 5 – New Station Setup
Property Description
Station Name The name of the station. If you have other loggers, the name is used to distinguish them.
Logger Set this to “Ecotech Serinus” when downloading from any Serinus series instrument. This
will communicate with the instrument on the
Advanced protocol. If using a network or
serial connection, ensure that the Advanced protocol has also been selected on the
instrument itself.
Time Zone Set this to the time zone that the instrument is located in.
DST Enable this option if you plan on changing the clock on the instrument with daylight
savings. Leave this disabled if the clock does not shift during DST. The instrument will need
to be adjusted manually for DST – it will not happen automatically.
Database Name This is the name to be used for the table in the SQL database containing this station’s data.
It must be unique for each station.
Device ID Enter the Serial ID of the instrument .If you are not using multidrop; this can be set to “0”
or left blank.
Link Type Select the type of connection used to connect to the instrument. Different properties will
appear depending on the link type selected. Make these align with t with those of the
instrument.
Log Interval This needs to be the same as the Data Log Interval setting on the instrument.
Note: The available fields for communication parameters will change when you change the link type.
You will need to set the communication parameters that have been defined on the instrument.
5. Once the station has been created, save the station by clicking the Save shortcut icon or
File

Save.