Installation
38/ 100
Oleolift-C
3.3.10 Installation in the outdoor cabinet (optional)
Outdoor cabinet for accommodation of accessories
Specifi cations:
■
The construction materials used and installation method must not cause any harmful
deformations, damage or unfavourable load cases for the outdoor cabinet.
■
Use base filler (fill material for reducing the formation of condensation).
An outdoor cabinet for accommodating
the control unit, fl ashing light, horn,
etc. can be purchased from ACO as
an optional product. Components such
as the control unit, heating, working
socket,... are then usually already
pre-assembled in the outdoor cabinet.
Î
Make a hole in the ground for the outdoor
cabinet (1), note the buried depth (3)
(
outdoor cabinet data sheet).
Î
Build the foundation (4) for the outdoor
cabinet (1) and at the same time position
the cable duct above the foundation.
Î
Install and fix the outdoor cabinet (1)
onto a foundation (4).
Î
Feed through the cables (6), e.g. with
cable glands (8) and end cover (7).
Î
Fill the void (2) with base filler.
Î
Backfill the excavated hole.
6
7
8
1
2
3
4
5
Outdoor cabinet for accommodation of a backflow loop
Specifi cations:
■
The construction materials used and installation method must not cause any harmful
deformations, damage or unfavourable load cases for the outdoor cabinet.
■
Install the backflow loop not necessarily “filling the cabinet”. It is sufficient if the pipe
bottom of the backflow loop is located above the backflow level on site.
■
The backflow loop must be protected on site against the effects of frost e.g. by utilising
trace heating tape.